Trailer for the FPV-Rover
Trailer for the FPV-Rover
Published 2019-06-24T12:06:46+00:00
This is a remix of the OpenRC Truggy designed by Steamerzone.
http://www.thingiverse.com/thing:378042
The tires are a remix of the small tire by Bastien.
http://www.thingiverse.com/thing:626863
It is designed for the FPV-Rover (V1.0)
http://www.thingiverse.com/thing:1240754
And for the FPV-Rover (V2.0)
https://www.thingiverse.com/thing:2952852
Instructions:
Print everything with 15%-25% infill. Support not needed.
Use PET, Flexifil, Ninjaflex... for the tires.
Due to the limitation of my printbed I had to cut some pieces into more parts. If your printbed is big enough, print the complete parts (like, frame front, frame rear, fender, ramp, front).
Parts to print
1x fender
1x front
1x center
1x frame hitch
1x frame front
1x frame rear
1x hinge
2x side
4x tire
4x rim
Parts you need:
2x M5 threaded bar (23cm-24cm)
8x M5 nuts (for each wheel two to center the wheel on the threaded bar)
1x 6mm metal pipe with 5mm hole
1x M3 threaded bar (7cm-8cm)
1x M3 nut
2x M3 washer
1x spring from a pen
M3 16mm screws
M3 10mm screws
Date published | 24/06/2019 |