Tyrion Lannister
Tyrion Lannister
Published 2017-03-12T11:18:14+00:00
This is my model of tyrion lannister, it was printed in pla at .1mm layer height with a .3mm nozzle. the culpting of the series of models based on "the binding of isaac" were paused while i was finishing tyrion
Note that you will have to glue all pieces together xD, since the cup is so little and the only contact point are his fingers, it was obvious that i was gonna have to use glue to hold it in place ( without glue, it stays in place if you dont move the figurine though), and as i was already gonna use glue well...didnt bother to make the arm press fit pin
hope you like it, and if you want to support me and my models, you could consider tipping me, i would really apreciate, thanks!
Date published | 12/03/2017 |
Time to do | - 900 minutes |
Material Quantity | 63.04 g (0.14 lb) |
Dimensions | 70mm x 70mm x 133mm |
Painted (poorly lol)