Wolf Whistles... easy and fun multi pitch whistles!
Wolf Whistles... easy and fun multi pitch whistles!
3D
Published 2017-03-20T19:21:05+00:00
Wolf Whistles are a small, easy and 'loud' prints. Keep one handy all year round for sports, in case of emergencies and fun for Halloween or use them as a small low cost gift.
The outer chambers are a different length from the centre chamber so, when blown hard, make different pitch 'ear piercing' sounds. Combined they make a loud dual pitch whistle... or place a finger/s over the outer or centre holes to change the pitch.
There are plenty of 'whistles on Thingiverse however the Wolf Whistle is as much about a fun way to present a whistle as it is about producing an actual 'wolf whistle' but, with a bit of practice and experimentation with finger positions, you can achieve sounds representing a Wolf Whistle
There are two different Wolf Whistle stl's provided. One is for a standard whistle and the other includes a facility to place it onto a key ring.
For additional information please refer to the images and print setting.
Note: If you like this check out the rest of my fun and practical designs.
Easy print... to make your Wolf Whistles multi-coloured pause the print at 3mm / 35 - 40% print progress.
Check the openings...
Wolf Whistles should work well straight off the build plate however check all of the openings to make sure they are clean and free of filament debris which could disrupt airflow. A well set up machines / good slicing app should deliver a sharp ready to use whistle.... just give it a good hard blow!
| Date published | 20/03/2017 |
| Technology | FDM |