roybijster's Print of Tentacle Set - Standard License
Community Print 3D Print of Tentacle Set - Standard License
Published 2021-03-29T08:43:55+00:00
10
0
Printed on: Prusa i3 MK3
Material: PLA
Description
Printed in PLA with FDM, layer height of 0.1 mm.
Tentacles 1, 2 and 4 (left to right and same numbers as in the filenames) print well in upright position with minimal supports. Tentacle 3 cannot properly be supported this way and the print failed 2 times. I had to tilt the print (See photo) to make it work, but this orientation results in visible print artifacts caused by the supports.