Jon @InvertedPrint001 - MyMiniFactory

Jon

Username: InvertedPrint001

Objects (0)
Prints (3)
Collections (0)
Followers (1)
Following (0)

Scavenger Legionnaire

Station Forge
GrimGuard - Battle Tank

Station Forge
GrimGuard Flame Tank
$I had to use a dremel, a sander and plastic putty, but that was the fault of warping of the two hull pieces. I also had to cut off the locator pins on the treads in order to fit them on the hull. These problems were entirly due to my printer baseplate not quite being level. This affected the trailer as well. The seams on the fuel tanks look a little rough. Also, for the hollow parts such as the treads, it may be best to cure them in a tub of water. The water would refract the light into the interior of the treads better than not. The material I used was the standard 8k Elegoo Resin. I would recommend this flame tank print. It is very well designed.$
Station Forge